how to install sharkbite fittings on existing copper pipe

This Kind of Customer Service is Above and Beyond. 1 Use a tapered wrench to tighten the fitting onto the pipe.

6 Sharkbite Mistakes Not To Make Got2learn Youtube

CONNECTING THE FITTINGS 1.

. Lowes Has Your Next Project Covered. Pull the fitting to remove it from the pipe. 2 Make sure the fitting is tightened until the threads are flush with the surface of the pipe.

How To Install SharkBite Brass Push-To-Connect FittingsIdentify the pipe material. Cut pipe cleanly squarely. Rotate the fitting if necessary to help remove it from the pipe.

Make Your Plumbing Project A Success At Lowes. Ensure proper installation To ensure proper placement check and verify the depth mark made earlier is within 0005 inches from the end of the release collar. Position the pipe side prong so its fully seated on the pipe.

You should then mark each pipe joint on end to show where the SharkBite fitting will fit. Ad Knowledgeable Associates Here To Help. To get started identify the pipe material.

Also when dealing with copper pipe and non-conductive brass SharkBite fittings its a good idea to install grounding clamps connected by. Home To Any Budget Home To Any Possibility. Connect the male fitting to the female fitting using the supplied hose clamps.

Ad Your One-stop Shop for All of Your Plumbing Needs. Just push the tube into the fitting until you reach the depth mark. Ad Be Prepared For Your Next Job With the Most Reliable Fittings Available.

Insert copper pipe in the Suitable SharkBite Fitting Slightly turning the line push the pipe in the fitting until it. And finally the installation is over turn on the water and check the connection. Place the fitting side above the barrel of the SharkBite fitting.

Hear What Our Customers Say. To check if the installation of the pipe is accurate and proper you must verify and see if the depth marked is within 0005 inches of the release collar ending. Place the fitting side above the barrel of the SharkBite fitting.

There is no need for special tools or clamps. 177779 views May 24 2018 Installing a Tectite Sharkbite Slip Tee onto a copper water pipe line. Tighten the clamping ring on the male fitting.

Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possibleMeasure mark the insertion depth. Squeeze the handle to compress the release collar which is what makes the fitting let go of the pipe. NOTE De- burr and Clean the inside AND outside of pipe after cutting.

Once youve cut the pipe so that its square use the SharkBite Depth Deburr Gage to mark insert depth on your pipe. Hold the pipe firmly and push it into the SharkBite fitting with a slight force until it hits the tube spot.

Replacing Copper Pipes And Fittings With Sharkbite Push Fit Connectors Youtube